Splitter Sending video to two projectors

We need to send one 1080p video signal from a laptop to two Epson 4770w video projectors. The projectors are located approximately 150 feet cable-run distance from the laptop. The projectors are spaced 50 feet apart.

We need a pair of HDMI extenders. There are no walls between the laptop and the projector. Line of sight distance is approximately 90 feet. (Cable run is 150 feet.)

We can run one CAT-6 STP 23 AWG solid copper conductor cable from the laptop location to each projector. Total of two cables.

You offer so many solutions. We need a rock-solid solution. The video receivers at the projector will not be accessible. Thus, we cannot have situations in which the receiver must be "reset". Power over the CAT-6 cables is nice, but power outlets are available at the projector locations.

We can go either wireless or wired.

The projector supports 1080p. We will NOT be using 3D or deep color or 4K resolution. This is a church setting. Both projectors will display the same video signal at all times. We may need an HDMI splitter or an HDMI Distribution Amp to drive both transmitters. Thus, you may need to recommend a signal splitter and two pair of transmitter/receivers unless loop-through is provided at the transmitter.

We will need to extend IR control to the projectors.

Can you offer a recommendation for a solid solution? We do not need the cheapest solution, but we do not need to purchase capabilities far beyond our technical requirements. Only reputable brands should be considered.